드론/멀티콥터
     D_자동차(종류별)
     스케일 악세서리
     바디/액세서리
     타이어,휠/액세서리
     자동차 공통부품
     쇽/쇽파트
     부품리스트(자동차)
     보트/요트
     조종기/액세서리
     엔진/부품
     엔진부품리스트
     머플러,매니폴드/액세서리
     연료,시동용구/액세서리
     모터,변속기/액세서리
     충전기,배터리/액세서리
     오일,접착제,케이블
     나사,너트,와셔,링
     RC공구/셋팅게이지
     캐리어백/케이스/기타
     멀티콥터/헬기/비행기
     부품리스트(헬기)
     철도모형
     카탈로그/책
     헬기키트
     기타부품

현재위치 HOME >>모터,변속기/액세서리 >>전자변속기(브러시리스모터용)

 KINETIC RACING BRUSHLESS ESC
 상품코드 NV1740
 권장가격 324,000 원
 판매가격 324,000 원
 제조사 NOVAK
 적립금 3,240 원
 
 구매수 재고없음
관련상품


현재 품절된 상품입니다.



KINETIC RACING BRUSHLESS ESC FEATURES
Novak's Dynamic Timing Advance™ increases the motor's RPM dynamically through the throttle band
Maximum-available electronic-motor timing – more than 50 degrees plus boost with eight on-board settings
Compatible with the NovaLink™ for advanced programming options including fine tuning of timing, ESC and motor temperature diagnostics and adjustable boost delay
Software updates for the Kinetic can be updated via the NovaLink™
Electronic Power Control™ feature to fine tune vehicle power delivery and response
Multiple adjustable parameters via on-board or optional PC interface: Minimum Brake (0-30%), Drag Brake (0-30%), Minimum Drive (0-15%), Timing Level (0-55° + boost), Timing Set Point (19,500-4,000), Current Limit (10 settings), Dead Band (2-8%), Throttle Curve (Linear/Expo), Brake Curve (Linear/Expo),  Brake Frequency (1.67-13.7 KHz), Brake End Point (10-100%), Drive Frequency (16-7 KHz),  Reverse, Motor Rotation, Voltage Cut-Off, Hall Sensor Test and Throttle Profile
Approved for ROAR Sportsman Class Racing
On-board Hall Sensor Test to easily and quickly verify that the motor's sensors are working properly
NovaBrakes™ provide instantaneous braking under any timing condition
Sensor-based for excellent torque and low-speed driveability
User friendly on-board programming interface with five colored status LEDs
Robust 3-amp BEC for strong and fast steering response under any condition
Compatible with the entire 540-sized and 550-sized Novak brushless motor line
Battery Type Selection circuitry for Li-Po, Li-Fe and Ni-MH battery packs
Locked Rotor Detection and Thermal Overload Protection with on-board temperature diagnostics
Included 25x25x10mm ESC cooling fan (#5649)
Eight layered, 2 oz., copper-clad PC board for lowest possible power loss
Water-resistant case with a protective silicone gasket
Cross-cut ESC heat sink for reduced weight and efficient cooling
The Kinetic's firmware can be updated via a PC using the NovaLink™
Meets RoHS compliance and includes 120-Day Warranty
Designed, assembled and tested by Novak in Irvine, Calif., using globally sourced components
　
KINETIC RACING BRUSHLESS ESC SPECS
Design: Sensor based
ESC Weight (without wires): 1.29 oz. (36.60 g)
Input Voltage: 2S Li-Po cells, 2S Li-Fe cells or 4-6 NiMH cells (1.2V/cell)
ESC Footprint: 1.16” x 1.47” (29.5 x 37.3 mm)
Motor Limit: Any ROAR-approved 540-sized* and 550-sized sensored brushless motor
On-Resistance: 0.00040 ohms @ 25°C trans. temp.
BEC: 6.0 volts DC / 3.0 amps
Status LEDs: 5
Voltage Cut-Offs: 6.25V (Li-Po), 4.75V (Li-Fe) [adjustable via NovaLink™]
Power Wires (battery/motor): 14G Super-Flex Copper-Strand Silicone Wire
*Advanced motor timing must not be used for 3.5 to 5.5-turn 540-sized motors
　
REPLACEMENT / OPTIONAL PARTS
#5304 (optional) or #5309 (replacement) Plug-In Input Signal Harness (Mini-JST)
#5332 Brushless Motor Connector Wire Set (optional)
#5440 NovaLink Programming Interface (optional)
#5508 14-Gauge Silicone Brushless Wire Set (replacement)
#5512 Super-Flex Silicone 12GA Wire Set (optional)
#5602 Remote Power Programming Switch (replacement)
#5649 Black Cooling Fan 25x25x10mm - 2mm Mini Plug (replacement)
#5679 Racing Power Trans-Cap Module - 2S Li-Po and 4-6 cell Ni-MH (replacement)
#5731 Low-Loss Power Connectors – 3.5mm (optional)
#5741 4.0mm Low-Loss Power Connector – 5 pairs (optional)
KINETIC RACING BRUSHLESS ESC FEATURES
Novak's Dynamic Timing Advance™ increases the motor's RPM dynamically through the throttle band
Maximum-available electronic-motor timing – more than 50 degrees plus boost with eight on-board settings
Compatible with the NovaLink™ for advanced programming options including fine tuning of timing, ESC and motor temperature diagnostics and adjustable boost delay
Software updates for the Kinetic can be updated via the NovaLink™
Electronic Power Control™ feature to fine tune vehicle power delivery and response
Multiple adjustable parameters via on-board or optional PC interface: Minimum Brake (0-30%), Drag Brake (0-30%), Minimum Drive (0-15%), Timing Level (0-55° + boost), Timing Set Point (19,500-4,000), Current Limit (10 settings), Dead Band (2-8%), Throttle Curve (Linear/Expo), Brake Curve (Linear/Expo),  Brake Frequency (1.67-13.7 KHz), Brake End Point (10-100%), Drive Frequency (16-7 KHz),  Reverse, Motor Rotation, Voltage Cut-Off, Hall Sensor Test and Throttle Profile
Approved for ROAR Sportsman Class Racing
On-board Hall Sensor Test to easily and quickly verify that the motor's sensors are working properly
NovaBrakes™ provide instantaneous braking under any timing condition
Sensor-based for excellent torque and low-speed driveability
User friendly on-board programming interface with five colored status LEDs
Robust 3-amp BEC for strong and fast steering response under any condition
Compatible with the entire 540-sized and 550-sized Novak brushless motor line
Battery Type Selection circuitry for Li-Po, Li-Fe and Ni-MH battery packs
Locked Rotor Detection and Thermal Overload Protection with on-board temperature diagnostics
Included 25x25x10mm ESC cooling fan (#5649)
Eight layered, 2 oz., copper-clad PC board for lowest possible power loss
Water-resistant case with a protective silicone gasket
Cross-cut ESC heat sink for reduced weight and efficient cooling
The Kinetic's firmware can be updated via a PC using the NovaLink™
Meets RoHS compliance and includes 120-Day Warranty
Designed, assembled and tested by Novak in Irvine, Calif., using globally sourced components
　
KINETIC RACING BRUSHLESS ESC SPECS
Design: Sensor based
ESC Weight (without wires): 1.29 oz. (36.60 g)
Input Voltage: 2S Li-Po cells, 2S Li-Fe cells or 4-6 NiMH cells (1.2V/cell)
ESC Footprint: 1.16” x 1.47” (29.5 x 37.3 mm)
Motor Limit: Any ROAR-approved 540-sized* and 550-sized sensored brushless motor
On-Resistance: 0.00040 ohms @ 25°C trans. temp.
BEC: 6.0 volts DC / 3.0 amps
Status LEDs: 5
Voltage Cut-Offs: 6.25V (Li-Po), 4.75V (Li-Fe) [adjustable via NovaLink™]
Power Wires (battery/motor): 14G Super-Flex Copper-Strand Silicone Wire
*Advanced motor timing must not be used for 3.5 to 5.5-turn 540-sized motors
　
REPLACEMENT / OPTIONAL PARTS
#5304 (optional) or #5309 (replacement) Plug-In Input Signal Harness (Mini-JST)
#5332 Brushless Motor Connector Wire Set (optional)
#5440 NovaLink Programming Interface (optional)
#5508 14-Gauge Silicone Brushless Wire Set (replacement)
#5512 Super-Flex Silicone 12GA Wire Set (optional)
#5602 Remote Power Programming Switch (replacement)
#5649 Black Cooling Fan 25x25x10mm - 2mm Mini Plug (replacement)
#5679 Racing Power Trans-Cap Module - 2S Li-Po and 4-6 cell Ni-MH (replacement)
#5731 Low-Loss Power Connectors – 3.5mm (optional)
#5741 4.0mm Low-Loss Power Connector – 5 pairs (optional)


  이용안내 - 마이쇼핑 - 장바구니 - 신제품리뷰 - 개인정보취급방침 - 자료실 - 고객게시판